Set your bottom VFO B with your UHF frequency of choice (between 400-520 MHz) Set your top VFO A with your VHF frequency of choice (between 136-174 MHz) The cross-band repeat function also supports CTCSS (or PL) tone encoding if you choose to use it.
channel or memory mode) in the new V4 TH-UV8000D radio, but both modes will work with the cross-band repeat function (when properly set up).
RADIO TYT UV8000E MANUAL HOW TO
Not only will that help preserve battery life, but your radio will be much cooler and the battery will last longer as well.įifth, the example that follows will show you how to set up a cross-band repeat function in VFO mode (vs. Since one advantage of the TH-UV8000D radio is that it comes with a higher performance (and longer) gain antenna, try using the low power setting when using the cross-band repeat function whenever possible. their mobile radio counterparts that have both a larger heat sink and a fan for cooling), so it's highly recommended that you keep your cross-band transmissions as short in duration as possible and NOT use high power unless absolutely necessary. Instantly re-transmitted on your selected UHFįourth, hand-held radios do not have cooling fans (just a relatively small heat sink vs.
Heard on your selected VHF frequency will be V4 of the TYT TH-UV8000D radio will operate inīoth directions automatically, meaning that a signal Third, the cross-band repeat function in the new Separation to accomplish the same task (plus itĬosts a lot less and removes many pounds of Radio designers use many MHz of frequency Hand-held radio like the TYT TH-UV8000D, so the Picture on right) that's just not feasible in a small KHz apart on VHF (using expensive receiverĬavities to separate the two close-by signals, see Have transmit and receive frequencies just 600 Repeater costing several thousand dollars can Several MHz of separation between the transmitĪnd receive frequencies in order to performĬorrectly, so while an expensive commercial
RADIO TYT UV8000E MANUAL SERIAL NUMBER
To ensure that each unit has been tested prior to shipment, we record each radio's serial number after testing and before shipment to the customer.Ĭommunications, a cross-band repeater needs This is measured with the included charger.First, not all TYT TH-UV8000D radios have the cross-band repeat function supported in the radio's firmware (all current versions shipped by RF Gear 2 Go have been tested by us prior to shipment to ensure that you get the latest radio firmware, thus allowing the cross-band repeater function to work). Q: How long does it take to charge the battery?Ī: It takes around 8 hours to charge the battery. Q: What is the capacity of the battery it comes with?
There is no indication whatsoever that the cross-band repeater function is active. Is my radio broken?Ī: The radio is not broken. However, there is no indication on the display showing that the feature is active. Q: I have enable the cross-band repeater function on my radio, turned it on and it works. Double-click “Optional Function” on the left and check the “Cross-band setting” box at the bottom-right of the Optional Function window that will appear. You can only enable this feature through the TYT software. Why?Ī: The radio comes from the factory with the feature disabled by default. I am setting menu item #11 “TURN” to “ON” but it doesn’t work. Q: I am trying to use the radio in cross-band repeat mode. It also supports 25 separate memories for storing FM broadcast stations. “2 x 128 memories” is either an error or exaggeration on behalf of some sellers. Q: How many memories does it have? I am confused by many seller listings that state “2 x 128 memories” and such.Ī: The radio has 128 memories. Press “F” again to confirm, or “U/V” to cancel the operation. Q: How do I reset the radio to factory defaults?Ī: Press and hold the “F” (Function) key while switching the radio on.